Select "Add," then type in your user name. Launch the ACTIV Studio for the first time by double-clicking the desktop icon. To right-click, press the orange button on the body of the pen, then press the nib to the screen. To double-click an application, simply press the nib of the pen to the screen until you feel a rapid click twice in a row. Use the ActivPen the same way you use a mouse the tip of the pen-the nib-acts as the left mouse button, and the orange button on the body of the pen acts as the right mouse button. You can alternatively right-click on the ActivManager icon, located in the bottom right-hand corner of the screen, and select "Calibrate." Follow the on-screen instructions to successfully calibrate the screen. Wait for the board to beep, then follow the on-screen directions to calibrate the screen. Hover the pen over the gray dot in the upper left-hand corner of the screen. Adjust the focus and lens to center the image on the center of the board-the corners of the screen should match up with the corner markers on the ActivBoard.Ĭalibrate the ActivBoard to use the pen with the board. Position the projector in front of the ActivBoard. The projector will display your computer's desktop image onto the board. Plug the LCD projector into an electrical outlet and turn it on. You will see a blue light and a red blinking light, indicating the ActivBoard is powered and ready to use. Plug the other end of the power cable into an electrical outlet. Please reference the link provided below for firmware for the 100 and 300 Series ActivBoards. This will apply to all sizes.Plug the black power cable into the serial port cable attached in Step 4. Please reference the link provided below for firmware for the 95” 500 Series ActivBoard. Please reference the link provided below for firmware for the 87” 500 Series ActivBoard. Please reference the link provided below for firmware for the 78” 500 Series ActivBoard. Once you have downloaded the appropriate file, change the ‘ Source’ from ‘ Internet’ to ‘ File’ from the process stated above. You can verify your specific model board by inputting the serial number into the form on Promethean’s website here: Make sure you download the correct file for the board you have. To do this, go to the Windows Control Panel and open Tablet PC Settings, then click Setup and follow the instructions on the screen.įor full details regarding this firmware update, please read the support document released by Promethean here and read the post made by Promethean on their forums here. If you are unable to download the file automatically via the above process, you can download the file below. Note: You may need to configure Windows 10 to allow the Stylus input to work on your ActivBoard as the second screen.Open ActivManager’s Control Panel and click on the Pens tab.Pen interaction in extended desktop will only work if ActivManager is set to Tablet mode.The ability to launch calibration by hovering your ActivPen over the flame LED will be disabled.There are two important things to note with this change: Once the upgrade is complete, the Promethean flame will flash green until you tap your ActivPen on the ActivBoard surface. For users of 500 series ActivBoards, do not operate the ActivBoard with your finger until the Promethean flame stops flashing. A confirmation dialog opens click OK then Close. The Promethean flame on your ActivBoard will flash magenta until the upgrade is complete.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |